Composition:
Gold 2.0%
Palladium 76%
Copper 7.5%
Indium 8.0%
Gallium 6.5%
Balance Ru
Color: White
Applications: OSAGE 76 is a white colored noble silver free palladium porcelain-fused-to-metal alloy. It is designed for single units, and short and long span bridgework.
Physical Properites:
| Casting Temperature | 2350F (1290C) |
| Melting Range | 2105-2150F (1150-1180C) |
| Density (gm/cc) | 11.2 |
| Vickers Hardness | 315 |
| Tensile Strength | 190,000 psi |
| Yield Strength | 160,000 psi |
| Elastic Modulus | 18,000,000 psi |
| Elongation(%) | 16 |
| TCE x 10-6/C(25-600C): | 14.3 |
Recommended Processing:
| Recomended Solders | Pre GPW, Post GPY |
| Recommended Investment | PB-CF |
Soldering: Pre solder using Gateway GPW solder without flux. Post solder using Gateway GPY solder.
Spruing:
Single crowns - Direct method with 8 ga. sprues and adequate resevoirs.
Multiple Units and bridges - Use 6 ga. runner bars with 10 ga. sprues to units and 8 ga sprues to the sprue base.
Investment: Use a high-heat carbon-free phosphate-bonded investment following the manufacturer's instructions.
Burnout: After adequate set-up time, place ring(s) in oven at room temperature and raise temperature to 800F (425C) and hold for 30 minutes. Raise temperature to 1500F (815C) and hold for 1 hour plus ten minutes for each additional ring.
Melting and Casting: OSAGE 76 has a casting temperature of 2350F(1290C). Use a fuel/oxygen torch with multiorifice tip. Do not use flux. Allow to bench cool before divesting. Add 50% new material to buttons. Do not use graphite crucibles.
Finishing: Grind metal surfaces for porcelain applications with noin-contaminating aluminum oxide stones. Blast with new 50 micron aluminum oxide. Clean in distilled water in ultrasonic cleaner for 10 minutes.
Degassing:Place units in a 1200F (650C) oven and raise temperature to 1850F (1010C) without vacuum. Hold for 5 minutes. Remove at once and bench cool. Remove oxide with new 50 micron aluminum oxide. Clean in distilled water in ultrasonic cleaner for 10 minutes.
Opaquing: Follow porcelain manufacturer's instructions.
| home | white pfm alloys | msds |